Week 8 - Challenge 3 - Coin Holder Design

What is under Body Coating: Underbody coating is a thick cladding (typically made of rubber) that is placed uniformly on the car’s underside. When the automobile is fresh off the lot and spotless, it is usually sprayed or painted on. But it’s acceptable if you apply the undercoating after a couple of years.…

Objective: 1. What is Benchmark and presently available cars with benchmarking in the market, also explaining the below following case 2. Comparing at least 4 vehicles. 3. Provide a proper conclusion for the report, suggesting a single suitable vehicle among the comparison made with images. Given Case: Mr. D.S. Pughazhyendhii is…

AIM     To make a full solid model from the provided master section and class A surface. INTRODUCTION: CATIA:          It means Computer-Aided Three-Dimensional Interactive Application.  It is computer aided designing software. This is software which…

   AIM     To make a fully solid model from the provided lower door trim A surface and make DOG HOUSE. INTRODUCTION: CATIA:          It means Computer-Aided Three-Dimensional Interactive Application.  It is computer-aided designing software. This is software which is used to design 3D models with different workbenches.…

I GOT A GAP IN  [CLASS A] SURFACE I ALTERED THE GAP AND I CREATED A JOIN OF [CLASS A] SURFACE AFTER CREATED A [CLASS B]  SURFACE AND [CLASS C]. IN [CLASS C] ALSO GOT SOME MINUTE GAP IT TOOK TIME TO ARREST. AFTER TRIM [CLASS A] TO [CLASS C] FOLLOWING TRIM TO [CLASS B]