Flow Simulation using SolidWorks-Modelling and simulation of flow through a flowbench

Introduction The purpose of this challenge is to perform an explicit dynamics simulation to find out the Equivalent Stress, Total Deformation and also insert a User defined result to calculate the temperature of the body.We will be performing simulation for 2 cases. Case 1: Cutting velocity of 20000mm/s Case 2:cutting…

Introduction The purpose of this challenge is to  perform the tension and torsion test on a given specimen. The test will be divided into two cases Case 1:Tension test where one end is fixed and the other end is displaced axially by 18mm Case 2:Torsion test where one end is fixed and the other end is twisted…

Introduction  The purpose of this challenge is to to perform CFD Analysis on a cyclone seperator. We will be running the simulation as two cases with each containing multiple Sub-Cases Case 1:Perform an analysis on the given cyclone separator model and apply four different boundary condition types at the inlet i.e.…

Introduction In this project we will be running a conjugate heat transfer analysis on a model graphics card. the parametres we will be looking for are as follows: 1. The maximum temperature attained by the processor. 2. Prove that the simulation has achieved convergence with appropriate images and plots. 3. Find out the…